- #Snap on ford ids update
- #Snap on ford ids software
- #Snap on ford ids Pc
- #Snap on ford ids windows 7
The new 2011 model year Ford Super Duty diesel has a new emissions system which includes a Selective Catalyst Reduction (SCR) system. It is important to know once the Padlock resource has been manually unlocked it will not be used again until manually restored or locked by the user. They can also return to the diagnostic test step and regain the resource by clicking on the Padlock button again to lock the resource. For example, if a user is using Interactive Measurements reading a PID in a diagnostic test step and now wants to run IDS or PTS Toolbox, they simply click on the Padlock button to unlock the resource, start IDS or PTS Toolbox and run the test desired. An Unlocked Yellow Padlock indicates the VCM and/or VMM resource is unlocked or not being used. A Locked Red Padlock indicates the VCM and/or VMM resource is locked and being used. Users that want to switch between Interactive Measurements diagnostics and the IDS or PTS Toolbox can click on the Red Padlock button to toggle the Interactive Measurement feature ON or OFF. The Interactive Measurements feature is currently available in certain 2007 through 2011MY PC/ED (Powertrain Control/Emission Diagnosis) and the 2010 & 2011MY EPAS (Electronic Power Assist Steering) service procedures.
#Snap on ford ids Pc
The Red or Yellow Padlock button can be found in the upper right hand corner of the diagnostic page when using Interactive Measurements once the VCM and/or VMM is connected to the PC and vehicle. Users that access PTS (Professional Technician Society) with a PC loaded with IDS can share VCM and VMM resources with a simple click of the Padlock button. These applications now require the use of the black probe and a universal probe (T-015) to connect to the coil primary circuit for more accurate measurement results. IDS release 73 will feature the relative injector flow (high pressure fuel system) test for some 2011 F-150 with 3.5L GTDI engine depending upon PCM calibration.Īn enhancement has been made to the Ignition Test for 4 cylinder Visteon Coil-On-Plug engines. The PC hardware should be repaired or replaced the PC. If restaging the Operating System does not resolve the issue, assume the PC Hardware has an issue.Window XP users should only be using Service Pack 3.
#Snap on ford ids software
That will resolve any software related viruses and corruptions. If the PC hardware is adequate to run IDS, you should recommend running a repair on the PC Operating System (Window 7) or restaging the Operating System (Window XP) and reload IDS.PC hard drives should be at least 30% free. Recommend replacing the PC or adding additional RAM if the hardware is expandable.
#Snap on ford ids windows 7
PCs running less than 512MB of RAM on XP Professional or 1GB of RAM on Windows 7 are not adequate. Verify the PC has adequate RAM and Hard drive space.Possible causes for this issue may be that the RAM (Random Access Memory) is being consumed by Virus infections, Malware or failed Hardware. The aborted screen shown in Figure 2 identifies the Windows Services by names, as you would see them if you looked under services in Windows Task Manager. It will not stop a technician from using IDS to repair a vehicle. This action will only delay IDS from opening. This will prevent the IDS software from starting until the proper Microsoft Windows Network Services are running. Therefore, we are releasing an IDS Start-Up warning in IDS R73. If IDS attempts to communicate with a VCM prior to those services starting, communications are not possible and IDS will usually produce Testman or Tabman errors. New 6.7L Diesel Service and Diagnostic ToolsĬommunications between IDS and the VCM relies on Microsoft Windows Network Services being started before the PC is connected to the VCM. Using PTS Interactive Measurements and IDS or PTS Toolbox at the Same Time
#Snap on ford ids update
Ignition Test Update for 4 cylinder COP Applications